How To Remove Bondo
How To Remove Bondo. Clean repair area with warm, soapy water or a surface cleaner to remove dirt, oil, dust or contaminants; A good body shop can repair most dents using bondo.
If you lay it so the angle of the chisel end is parallel with the sheet metal, you can chip off huge chunks of the filler, and not damage the sheet metal. Color is also a bit of a pain to work with if you don't have a spray gun. Make long sweeps for sanding over the repair.
Paint Stripper Will Remove The Bondo.
Heat will destroy the panels, and i am afraid elbow grease will as well. Litestab · harlem body kit has to go. Using a heat gun to remove old bondo.
Within Seconds The Paint And Filler Will Bubble And Burn.
Sanding old filler can send a plume of dust throughout the shop, but using a heat gun instead can make short work of removing old. Heat the old body filler with a propane torch. Crank up the flame and hold it against the painted/filled surface.
You'll Have To Grind, Or Wire Wheel Off The Thin Sections, But The Thick Ones Come Off Fast!
So, the only two ways of removing bondo were heat and elbow grease. I've used this method to remove thick layers of bondo extremely quickly! When stripping down old panels for restoration, it’s not uncommon to discover bondo hidden beneath that shiny coat of paint.
It's Not Very Fast Though.
Do not work a large area; Anything you can feel as wavy will translate through the paint. Either or will require some work.
Make Long Sweeps For Sanding Over The Repair.
The former owner bondoed over the insets for the badges on the side panels. If you are looking for more of a smooth paint job and don't want to pull the dents then bondo will work but you'd have to get it a good area of fresh. I am stripping the paint using a 3m clean and strip disc on a grinder (yes, i am being very careful with the grinder) anyways, my question is this:
Post a Comment for "How To Remove Bondo"