How To Put A Belt Buckle On A Belt
How To Put A Belt Buckle On A Belt. The belt buckle is larger than the lion head's hinge and would need the standard way of putting it on. Then insert the belt buckles into one of the holes in the belt.
Time to put the buckle on. Thread the belt end through each loop, pulling the belt through as you go. Put on a belt buckle without snaps:
A Pair Of Rivets Is Then Used To Fasten The Loop To The Belt.
To attach it, slide the belt through the buckle’s clip until the clip’s bar is centered between both the buttons and. Idk how good the audio i. To attach it, slide the belt through the buckle's clip until the clip's bar is centered between both the buttons and where the buttons are attached.
Then Insert The Belt Buckles Into One Of The Holes In The Belt.
Loop the unsnapped/undone part of the belt through the buckle, and then do the fastenings up again to close the belt around the buckle's hinge. Pull belt through the hinge. Secure the belt buckles to the part you want to stop after passing it through the belt.
Once You Reach The Last Loop, Buckle Your Belt.
This is a simple how to. You need a belt with two buttons at one end and a buckle. The buckle tongue should end up facing away from the strap loop, and the short end of the strap should be on the underside.
A Belt Then Becomes Not Only A Necessity To Hold Your Pants In Place, But A Fashion Statement.
Sorry about how bad i look i just woke up. I looked and couldn't find a video to help me in this situation. Once you have selected the belt to use, you can proceed to the belt buckles fastening process.
If Your Belt Uses Studs And Holes, Make Sure The Studs Are Fully Back Through The Holes Or You Risk The Buckle Falling Off.
You put the belt through this part and double the belt back, snapping it to hold the buckle in place. Put your belt on as you normally would. If your belt has an existing buckle, undo the buttons near the buckle, and slide the buckle off.
Post a Comment for "How To Put A Belt Buckle On A Belt"